Introduction
LANPOLYTMPPA2200B is free flow, 25 mesh white powder fluoropolymer based processing aid. At a very low level addition（50－800ppm), it can improve PE processing and without affecting the original physical property of the plastics as well as sealing, adhesion and printing, can be used for mLLDPE, LLDPE, HDPE, LDPE, EVA and other polyolefin resin.
Product Form
White to off-white powder
Application
Wire & cables, film, masterbatch and all other polyolefin extrusion process.
Product Functions
Improve film surface quality by eliminating melt fracture;
Reduce wears of a mold in the processing process, eliminate the die buildup;
Increase the ratio of LLDPE in LLDPE/LDPE blends for lower cost, higher quality;
Increase output and save energy.
Physical Property
Bulk Density 0.6-0.8g/cm3
Particle size <25mesh
Volatile <1（105℃ 1h)%
Processing Guide
The dispersion of PPA in resin determines the performance. The recommended process is to add PPA via
2%-3% Masterbatch through twin-screw extruder, and then add it into the extrusive resin according to
the ultimate goal. The conditioning time is 20-60 minutes according to the equipment, base material and
shear rate. No conditioning time when long-term use of this product.
